[gafoorcp]

I am facing the problem to run the setup with more than one MPI at a time. This problem is only for some setup and all other setups are running in multi mode in the same computer.But the same setup which is not able to run in multi mode in PCs( all 4 nos. spec: 2GB ram DDR3 1066GHz) is able to run in a workstation with high configuration.
i have faced this problem when i was trying to run an already completed solution by save as option into change some parameter. After several tries, i made it to run by loading the same file into a new folder and restarting the setup by editing the required parameters. but still i couldn't run the solution in two computers.
So please suggest me the possible reasons for this problem...
with regards
gafoor

[vivirichard007]

Originally Posted by gafoorcp

I am facing the problem to run the setup with more than one MPI at a time. This problem is only for some setup and all other setups are running in multi mode in the same computer.But the same setup which is not able to run in multi mode in PCs( all 4 nos. spec: 2GB ram DDR3 1066GHz) is able to run in a workstation with high configuration.
i have faced this problem when i was trying to run an already completed solution by save as option into change some parameter. After several tries, i made it to run by loading the same file into a new folder and restarting the setup by editing the required parameters. but still i couldn't run the solution in two computers.
So please suggest me the possible reasons for this problem...
with regards
gafoor

Hi Gafoorcp, I'm also facing the same issue. Models are running fine in workstation. But, when running on multi-node simulation doesnot start. If you found any solution can you please share?

Thanks.