[jonda319]

Hi, I'm completely new to AVL FIRE.

What I'm searching and have been unable to find is how to postprocess many simular cases smoothly. I want to run the simulations, then afterwards decide postprocessing results (will begin with different impress-cuts) that I'm going to export to a .dat file that I can postprocess in Matlab.

Is there a faster way to make a script or something where I can define which plane-cuts and settings I want in AVL FIRE and export these?

I've played around with macros in the GUI but it feels unstable and I havent found good documentation on how to write my own. Otherwise this would be a good idea.

Help appreciated!

[songül]

Hi everybody,

Now, I am working on split injection technologies in diesel engine that is pertain to my thesis.

I do my simulation in AVL -Fire .

But ı do not any idea about how can ı split fuel injection timing more than just one.

Have you guys knowing something about this?

Thank in advance

[Jason-zhang]

hello:

You can try to set the injection rate-shapes which will help you to realize the goal.
good luck!