Openfoam
Posted August 3, 2011 at 12:20 by mokcay
If anyone is interested in performing Openfoam analysis of a simple heat transfer problem for a fee please let me know. The problem:
•Flow through a rectangular duct with cylindrical obstruction
•Flow through a rectangular duct with cylindrical obstruction
•Turbulent flow (use k-e model)
•Initial Speed = > 3.5 m/s
•Water only (single phase)
•Fully developed velocity profile at inlet
•Pressure outlet (0 gauge)
•Steady state
•Heat transfer = 10 W/ (all surfaces) m2
•Initial Speed = > 3.5 m/s
•Water only (single phase)
•Fully developed velocity profile at inlet
•Pressure outlet (0 gauge)
•Steady state
•Heat transfer = 10 W/ (all surfaces) m2
Total Comments 1
Comments
-
Greetings mokcay,
You might want to try this site: http://www.extend-project.de/job-board/article/149 - It's been recently launched, as explained here: http://www.cfd-online.com/Forums/ope...tml#post318196
Best regards,
BrunoPosted August 6, 2011 at 20:25 by wyldckat
