CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Generating Surface Stream Lines with Paraview (From 3D data)

Register Blogs Members List Search Today's Posts Mark Forums Read

Rate this Entry

Generating Surface Stream Lines with Paraview (From 3D data)

Posted May 26, 2015 at 06:18 by Mehar

Being a Newbie, I have struggled to add surface streamlines to a slice, as I cannot find Appropriate instructions on this...However, after a long time struggle, I am able to add surface streamlines to a slice, which I would like to share with other newbies to avoid that head ace!

Following is the step by step procedure for generating surface streamlines!

1. Load Your Data in paraview
2. Add Slice filter to your Loaded Data
3. Add SurfaceVector filter to Slice
4. Add MaskPoint filter to SurfaceVector
5. Add StreamTracerWithCostumSource filter to SurfaceVector,a Dialogue Box will appear, select MaskPoint as Seed Source and Click Ok.

Wait for sometime, and Streamlines would be added to your Slice.
Note:
You Can Get Appropriate Streamlines by Playing With MaskPoints Setting "On Ratio", and "Maximum Number of Points"
Posted in Uncategorized
Views 7799 Comments 3 Edit Tags Email Blog Entry
« Prev     Main     Next »
Total Comments 3

Comments

  1. Old Comment
    Thank you so much !!
    permalink
    Posted April 4, 2017 at 04:40 by Ramsky Ramsky is offline
  2. Old Comment
    On Ratio is a good suggestion!
    permalink
    Posted June 16, 2017 at 11:05 by random_ran random_ran is offline
  3. Old Comment
    Thanks a lot.
    permalink
    Posted March 26, 2019 at 01:27 by saket411 saket411 is offline
 

All times are GMT -4. The time now is 21:45.