Exporting two different meshes simultaneously from salome to openfoam
Posted March 16, 2018 at 15:13 by p@nkaj
Hello,
This is my first post.
I want to export two different meshes at a time from salome 8.3.0 to (OpenFOAM-in-Box-18.02-r638).
I don't want to compound those meshes.
I used med and cgns formats to export, but failed.
When I exported using med, I was unable to convert it into foam file. I tried using ideasUnvToFoam <File_name>.med.
The polymesh folder was created, but all the files i.e. boundary, points, faces, neighbour and owner were empty.
and, When I tried to export using cgns it showed not enough memory on the disk.
Actually, I have created geometry in FreeCAD 0.16-6712 which is given in Tutorial of OpenFOAM in form of blockMesh.
i.e. OpenFOAM-in-Box-18.02/OpenFOAM-dev/tutorials/incompressible/SRFPimpleFoam/rotor2D and meshed it in Salome.
In one mesh I meshed for front, back and freestream and in other I meshed the rotor.
I grouped the geometry well.
I had exported compound mesh in unv and converted it using ideasUnvToFoam, but in paraview of Openfoam the blades of the rotor was not shown.
In Salome the exported unv file shows the correct mesh while in Openfoam rotor blades are not shown.
So, I want to export them individually.
This is my first post.
I want to export two different meshes at a time from salome 8.3.0 to (OpenFOAM-in-Box-18.02-r638).
I don't want to compound those meshes.
I used med and cgns formats to export, but failed.
When I exported using med, I was unable to convert it into foam file. I tried using ideasUnvToFoam <File_name>.med.
The polymesh folder was created, but all the files i.e. boundary, points, faces, neighbour and owner were empty.
and, When I tried to export using cgns it showed not enough memory on the disk.
Actually, I have created geometry in FreeCAD 0.16-6712 which is given in Tutorial of OpenFOAM in form of blockMesh.
i.e. OpenFOAM-in-Box-18.02/OpenFOAM-dev/tutorials/incompressible/SRFPimpleFoam/rotor2D and meshed it in Salome.
In one mesh I meshed for front, back and freestream and in other I meshed the rotor.
I grouped the geometry well.
I had exported compound mesh in unv and converted it using ideasUnvToFoam, but in paraview of Openfoam the blades of the rotor was not shown.
In Salome the exported unv file shows the correct mesh while in Openfoam rotor blades are not shown.
So, I want to export them individually.
Total Comments 0