CFD Online Discussion Forums

blog entry

Posted January 28, 2010 at 12:03 by CFDtoy

Sorry my blog entry was not clearly visible. I will try re-writing it here.

cfdtoy dot blogspot dot com

If you are not able to view the site here, kindly search for keywords: CFDtoy , blogspot.

I have placed several papers / presentations / documents on CFD modeling (mostly for multiphase applications) in Fluent and openFoam.

Several other reports on VOF, Eulerian-Eulerian modeling, Phase change such as cavitation, boiling (and modeling UDFs)...

CFDtoy

Senior Member

Posted in Uncategorized

Views 3100 Comments 1 CFDtoy is offline

Anyoon Rotary engine

Posted January 11, 2010 at 11:42 by dijinj

I had invented a rotary engine with efficiency of more than 79%. The new rotary engine achieves this by implementing both constant volume heat addition, water injection for cooling and Atkinson Cycle. Implementation of constant volume heat addition is considered to be a holy grail in IC engine design and Constant volume heat addition can provide 50% more power and there by efficiency over existing engines (assuming efficiency of existing engines is 30%) while using same amount of fuel(Ref: ‘Design...

dijinj

Member

Posted in Uncategorized

Views 3715 Comments 0 dijinj is offline

CFD blogging

Posted December 21, 2009 at 20:57 by CFDtoy
Updated January 28, 2010 at 12:05 by CFDtoy

I am trying to maintain a CFD blog at

cfdtoy . blogspot . com

Kindly post your thoughts / comments there.

CFDtoy

Senior Member

Posted in Uncategorized

Views 2496 Comments 1 CFDtoy is offline

NVD differencing

Posted December 18, 2009 at 20:28 by meda

The main purpose of high resolution schemes (HRS) which is usually plotted in NVD is to obtain bounded results. If it shifts to CD, it may cause under/overshoots which violates boundedness criteria. so almost all HRS (except SHARP of Leonard or SECBC of Tao) in such regions FOU is used.

meda

New Member

Posted in Uncategorized

Views 1744 Comments 0 meda is offline

Changing the grid... ( Hope this helps !!!!!)

Posted December 4, 2009 at 06:37 by calemarie

Handy for further use...

Quote:

Originally Posted by Toulouser
;138829

================================================ Duplicating the Case Setup for Different Mesh =================================================

On many occasions, it is necessary to replace the grid while retaining all of the settings for the case. It can be tiresome to start by reading a new mesh file and then duplicating the case setup by specifying settings through the GUI . In addition, there is always a chance for making an error when specifying

...

calemarie

New Member

Posted in Uncategorized

Views 3235 Comments 0 calemarie is offline