does this simulation make any sense ??

saleh alsubari · August 23, 2012, 01:11

becuase as u can see the velocity should decrease when the pressure increase and the vise versa ?? plz suggest

thanx

eRzBeNgEl · September 25, 2012, 14:36

i do not really understand your system, ist there a fan in the box? I assume an airflow direction from the left to the right. A Fan should increase the total pressure. After passing the fan there is a kind of diffusor, here the dynamic pressure decreases and the static pressure increases. This leads to less velocity after your "box". I see a lot of swirl after your box, so there is still room too improve the system. Dynamic enery after the system is a loss.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
compiling firefoam	Farshad_Noravesh	OpenFOAM	27	December 24, 2012 04:21
Small timestep make the simulation not converge	Anna Tian	CFX	1	August 7, 2012 19:25
Boundary Conditions - Transient Simulation	miki256	CFX	2	May 18, 2012 01:22
GUI crash and simulation engine still running	RPJones	FLOW-3D	2	November 9, 2010 08:18
in - pressure, out pressure, is that make sense?	Marteusz	CFX	6	July 15, 2009 14:33

September 25, 2012, 14:36		#2
eRzBeNgEl Senior Member Join Date: Dec 2010 Posts: 135 Rep Power: 15	i do not really understand your system, ist there a fan in the box? I assume an airflow direction from the left to the right. A Fan should increase the total pressure. After passing the fan there is a kind of diffusor, here the dynamic pressure decreases and the static pressure increases. This leads to less velocity after your "box". I see a lot of swirl after your box, so there is still room too improve the system. Dynamic enery after the system is a loss.