How to set segregate solver settings
 

hi,
i have read the tutorial of star ccm+ to understand about the segregated solver but when i am running the solver i am not getting any convergence in my solution i am attaching my setting picture and my convergence graph:confused::confused::confused::confused::conf used:Attachment 16824,Attachment 16825Attachment 16826,Attachment 16827

Dont depend on the residuals
 

Hello,

Please monitor the properties (pre,temp or any other) at inlet or outlet and plot the same. u will know the convergence of solution.

If you have any critical domains, then add probe point at the place and monitor the properties and plot the same. it will give you clear idea about what is happening in the solution and convergence.

I hope it will help you. Please inform me is this helpful to you.

Thanks for the reply and how to Define Inlet velocity profile and
 

hi,
thanks for reply.. i have set the monitoring points and monitoring its........i have one more doubt that if i want to set my inlet velocity profile as the parabolic then ,how can i setup this using the macro... do you have any idea regarding this... actually at the inlet condition the inlet velocity is set to be as uniform in star ccm+ but i want to enter with fully developed velocity profile into the inlet section can you help me. ...:confused::confused::confused::(

check this thread
 

Hi.. Please check the below threads, you will get answer


http://www.cfd-online.com/Forums/sta...-star-ccm.html

http://www.cfd-online.com/Forums/sta...ile-inlet.html