Mesh refinement in star ccm+

saram · December 31, 2012, 09:13

Hi guys,

I am doing mesh refinement in the star ccm+ of an impeller of centrifugal compressor. The mesh is polyhedral. Any suggestions how to do good mesh refinement of an impeller in star ccm+.

I shall be very thankful to all for valuable suggestions.

Regards

Saram.

Prashanth.A · January 24, 2013, 12:14

There are several ways to get around it, you could create a volumetric control and increase the mesh density. You could specify a small surface size and growth rate from the impeller. Bottom line is that there are multiple ways to get to the desired mesh. Some work amazingly quick and some take eons!. My suggestion would be to experiment as much as possible with the mesh and decide on the one which gives you acceptable y+ and Computational Cost.

December 31, 2012, 09:13	Mesh refinement in star ccm+	#1
saram New Member saram Join Date: Dec 2012 Posts: 1 Rep Power: 0	Hi guys, I am doing mesh refinement in the star ccm+ of an impeller of centrifugal compressor. The mesh is polyhedral. Any suggestions how to do good mesh refinement of an impeller in star ccm+. I shall be very thankful to all for valuable suggestions. Regards Saram.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Adding layers goes wrong with SnappyHexMesh	Elise	OpenFOAM Meshing & Mesh Conversion	1	April 22, 2013 02:32
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Mesh Refinement	JY	Siemens	7	September 19, 2002 13:37

January 24, 2013, 12:14		#2
Prashanth.A New Member Prashanth Avireddi Join Date: Sep 2012 Location: Farmington Hills, MI Posts: 10 Rep Power: 13	There are several ways to get around it, you could create a volumetric control and increase the mesh density. You could specify a small surface size and growth rate from the impeller. Bottom line is that there are multiple ways to get to the desired mesh. Some work amazingly quick and some take eons!. My suggestion would be to experiment as much as possible with the mesh and decide on the one which gives you acceptable y+ and Computational Cost.