Informatio transfer between models

December 8, 2002, 01:45

Hi,

Is it possible to transfer geometry and droplets properties from one case to another?

Regards,

Julie

December 8, 2002, 01:46

December 9, 2002, 05:18

You can use the facility of saving the mdl file info as cel, vertex, inp files etc. For example to save local.cel, local.vrt etc, you can use the PROSTAR command, cdsave,local.cel,local.vrt,local.bnd,local.inp,-1

why don't you try to import the inp file

December 9, 2002, 20:38

I think it'll be simpler to just copy the .mdl file and then do modifications from ProSTAR on it (assuming the new model is similar to your old one). CDSAVE was meant to make it possible to transfer geometric and setup data to other systems that your current binary files are incompatible with but frankly I haven't used it for that reason yet. I run STAR-CD under Windows, Linux, HP-UX, and IRIX.

December 8, 2002, 01:45	Informatio transfer between models	#1
Julie Polyakh Guest Posts: n/a	Hi, Is it possible to transfer geometry and droplets properties from one case to another? Regards, Julie

December 8, 2002, 01:46	Information transfer between models	#2
Julie Polyakh Guest Posts: n/a

December 9, 2002, 05:18	Re: Information transfer between models	#3
support Guest Posts: n/a	You can use the facility of saving the mdl file info as cel, vertex, inp files etc. For example to save local.cel, local.vrt etc, you can use the PROSTAR command, cdsave,local.cel,local.vrt,local.bnd,local.inp,-1 why don't you try to import the inp file

December 9, 2002, 20:38	Re: Information transfer between models	#4
CJ Tune Guest Posts: n/a	I think it'll be simpler to just copy the .mdl file and then do modifications from ProSTAR on it (assuming the new model is similar to your old one). CDSAVE was meant to make it possible to transfer geometric and setup data to other systems that your current binary files are incompatible with but frankly I haven't used it for that reason yet. I run STAR-CD under Windows, Linux, HP-UX, and IRIX.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two-fluid models vs mixture models for bubbly flows	Hansong Tang	Main CFD Forum	6	December 8, 2009 03:21
Conjugate heat transfer models	Alex	Phoenics	8	April 6, 2009 15:58
Heat Transfer in Multiphase Models (Star CCM+)	Luke Treadwell	Siemens	2	September 7, 2008 20:14
low-re models and heat transfer coefficient	Massimo	Main CFD Forum	5	December 22, 2005 02:57
CFD models	Xie	Main CFD Forum	0	April 18, 2002 13:48