Home > Forums > Software User Forums > Siemens

inlet

Mark Forums Read

Reply

Search this Thread

April 11, 2003, 06:11	inlet	#1
Sabatini Guest Posts: n/a	Hay I am trying to set boundary conditions of 'fully developed flow' at the square duct inlet without preliminary calculation. How can I set the BC's. Thanks.

April 22, 2003, 13:08	Re: inlet	#2
allan Guest Posts: n/a	methodology manual p 5-6 says for one layer of cells in the streamwise direction, impose a uniform pressure boundary on the 'inlet' plane and a prescribed flow outlet condition on the outlet plane allan

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
velocity inlet vs pressure inlet	cheong	FLUENT	6	April 9, 2011 03:07
subsonic inlet or supersonic inlet?	mali	CFX	0	November 28, 2008 20:57
about inlet bc	ivanyao	OpenFOAM Running, Solving & CFD	0	November 25, 2008 03:17
reversed flow at velocity inlet / mass flow inlet	ib	FLUENT	1	March 26, 2007 13:11
How to set smoke inlet speed on inlet	Adam	FLUENT	0	October 4, 2005 08:18

All times are GMT -4. The time now is 08:19.