Negative volume
Hi, How can I get rid of the Error message # 70, " Cells found with negative volume or volume less than specified value"? Thanks a lot. Mahbub alo_90@yahoo.com
|
Re: Negative volume
this error message means the cell has too small a volume. Are you using proam?
allan |
Re: Negative volume
Thanks. No, I'm using Prostar. How can I fix that? Mahbub
|
Re: Negative volume
Go to check tool and check the cells for 'left handed cells' criteria. Then click on the 'fix left handed cells' tab. and again check for -ve volume. It will definately solve the problem.
Thanks |
Re: Negative volume
Yes, the problem is solved. Thank you so much carno. mahbub
|
Re: Negative volume
Be careful!!!
There are left-handed cells which are simply defined incorrectly. There are also truely negative volume cells which are a cell quality issue. Best thing to do is inspect the cells. Don't push buttons blindly. Good luck. |
Quote:
|
The command is CFLIP, but it does depend on the cause. If they are extruded left handed, for example, this will work, If they are distorted then it ultimately will not.
|
All times are GMT -4. The time now is 08:42. |