|
[Sponsors] |
May 10, 2004, 15:08 |
Using DROPRO and POSDAT
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm modeling droplets injection into vaporizer of a combustion chamber. Heat transfer, saturation pressure and heat of vaporization are to be calculated by user subroutines. But after the first iteration appear the following two warnings: #528 posdat activated but not used #516 dropro activated but not used What is wrong? Regards, Julie |
|
May 14, 2004, 02:58 |
Re: Using DROPRO and POSDAT
|
#2 |
Guest
Posts: n/a
|
Either you have the switches activated but not programmed the code of you have programmed the user subroutines but not activated the switches. Be carefull sometimes when you change something in the droplet pannel Langrangian simulation is switched of when pressing apply.
good luck Michie |
|
May 14, 2004, 11:46 |
Re: Using DROPRO and POSDAT
|
#3 |
Guest
Posts: n/a
|
Hi Michie, which switches should be turned on?
Regards, Julie |
|
May 17, 2004, 02:55 |
Re: Using DROPRO and POSDAT
|
#4 |
Guest
Posts: n/a
|
I ment the radio buttons in the droplet pannel and the menu items in the parcel properties pannel. You set at least one of these to user.
Michiel |
|
May 17, 2004, 13:41 |
OK. Thanks
|
#5 |
Guest
Posts: n/a
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFL in posdat | hamodi | Siemens | 2 | August 6, 2007 02:27 |
POSDAT | Sheila | Siemens | 2 | February 8, 2006 11:08 |
User Subroutine DROPRO | Julie Polyakh | Siemens | 1 | June 27, 2002 07:05 |
posdat in HPC | Won-Geun Lee | Siemens | 0 | May 23, 2001 20:03 |
Posdat | Maria Carlsson | Siemens | 1 | April 30, 2001 10:29 |