|
[Sponsors] |
July 22, 2004, 07:40 |
Density out of bound
|
#1 |
Guest
Posts: n/a
|
can some one help me? I am solving a turbomachinary problem with compressible flow..density as a function of pressure and temprature.There is a warning in info file that density is out of bound due to pressure correction at cell.. limiter applied. please i am not able to understand what should i have to do. Thanks in advance for any help
|
|
July 22, 2004, 08:15 |
Re: Density out of bound
|
#2 |
Guest
Posts: n/a
|
Everyone has already had this warning....... I'm a novice as StarCD user, but I propose to you : - try to decrease your time step (have a look about 'Courant Number' in the user guide). - try to launch your run in double precision. - verify your molecular properties (Density : ideal f(T,P) / Viscosity : Multicomp. / Specific Heat : Polynomial / Conductivity : Multicomp. ).
Maybe decrease some relaxation factors could be helpful, but I'm not sure... Good luck. |
|
July 22, 2004, 08:23 |
Re: Density out of bound
|
#3 |
Guest
Posts: n/a
|
Thank you for your reply but i am solving a steady state flow and i am also using low pressure relaxation factor(0.03).Can any other reasons possible?
|
|
August 1, 2004, 22:35 |
Re: Density out of bound
|
#4 |
Guest
Posts: n/a
|
You can try transient solving. Good wishes!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Create an upper bound | daniel_mills | OpenFOAM Running, Solving & CFD | 0 | October 20, 2006 18:34 |
*** WARNING #060 *** DENSITY OUT OF BOUND DUE T | varun | Siemens | 0 | March 25, 2005 16:19 |
Bound node loop. | Jack Keays | FLUENT | 5 | July 9, 2000 13:57 |
Low Re k-e model bound. conds | Abhijit Tilak | Main CFD Forum | 1 | October 7, 1999 05:31 |
Compressible N-S bound. condn. | Kuttoosan | Main CFD Forum | 1 | July 6, 1999 12:46 |