|
[Sponsors] |
July 20, 2004, 09:05 |
STAR-CD cannot run normally.
|
#1 |
Guest
Posts: n/a
|
When I run my STAR-CD software from star launch,I can not run it normally,but there are some error massage as -------------------------------------------------------
******PROSTAR VERSION 3.103.519****** PRE/POST PROCESSOR FOR STAR-CD Licensing problem: Unable to list licensed features Cannot connect to license server The server (lmgrd) has not been started yet, or the wrong port@host or license file is being used, or the port or hostname in the license file has been changed. Server name: ndt License path: d:/PROGRA~1/STAR-CD/v3150A/license/license.dat FLEXlm error: -15,10. System Error: 10061 "WinSock: Connection refused" For further information, refer to the FLEXlm End User Manual, available at "www.globetrotter.com". Çë°´ÈÎÒâ¼ü¼ÌÐø . . . ------------------------------------------------------- To run my STAR-CD normally,what should I do? |
|
July 20, 2004, 12:19 |
Re: STAR-CD cannot run normally.
|
#2 |
Guest
Posts: n/a
|
The message is telling you that prostar can not get a valid license.
You need to fix your license problem. |
|
July 21, 2004, 09:29 |
STAR-CD cannot run normally.
|
#3 |
Guest
Posts: n/a
|
Thank you very much,Mr./Miss Pauli! But I have not solver the problem,can you tell me what I should do detailly?
Out of that problem,I have another problem: When I run my STAR-CD in the linux system atfer linking,the are some information,but I can not run my star. License info: CDLMD_LICENSE_FILE=/opt/v3100B/license/license.dat (from~/.flexlmrc) Checking out starsolver ***GEOMETRICAL CALCULATIONS STARTED ***GEOMETRICAL CALCULATIONS COMPLETED ?FORTRAN Runtime Error: ?Attempt to read past end of file ?Read(UNIT=9,...) |
|
July 21, 2004, 09:37 |
Re: STAR-CD cannot run normally.
|
#4 |
Guest
Posts: n/a
|
Unit 9 is the post file - this means you are trying perhaps to restart from a post file that does not exist, or contain the information required for a restart.
|
|
August 1, 2004, 08:50 |
Can not run CD
|
#5 |
Guest
Posts: n/a
|
Hi, I want to ask you that when I insert a CD in my computer its can not run. It shows "ERROR, can not run setup". I dont know that what the problem is with my computer. I hope you'll help us!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to export a mesh from star design to star cd | aounallah | Siemens | 4 | March 6, 2009 06:22 |
Star Design to Star-CD(Prostar) | AB | Siemens | 5 | October 28, 2004 12:21 |