BÚG REPORT for CD
 

1. geometry plot on screen 2. open cell tool add shell in table5 and on screen 3. cset news type5 4. cplot 5. WARNING NO CELL SELECTED FOR PLOTTING ** ERROR ** NO ITEM SELECTED FOR PLOTTING

version linux 32 bit 3.2

It would be nice, if you could remove this programming mistake.

thx

Re: BÚG REPORT for CD
 

Two possible problems here, and they're not bugs.

1) (The really obvious) Do you have any shell cells of type 5? If not, you can't plot them.

2) (Most likely problem) When you use the command GETV, dummy shell cells are created for interpolation of data on the boundaries. These shells are marked as invisible, so they don't clutter your plots.

Unfortunately, when you first issue the GETW command, a flag is set that marks all shells created from that point on as invisible, i.e. they can't be plotted.

The solution is quite easy. BEFORE creating your new shells, issue the command CLRW. This clears the flag, and all subsequently created shells can be plotted in the same way.

Re: BÚG REPORT for CD
 

THX

It works with CLRW