 |
 |
 |
|
|
|
[Sponsors] | ||||
December 2, 2004, 03:47
|
JOB STOPPED BY USER INTERVENTION
|
#1 |
|
Guest
Posts: n/a
|
Hello,every one! Here I have a problem: When I running star in module of prostar,the job stopped and there are information as
***CALCULATIONS TERMINATED-JOB STOPPED BY USER INTERVENTION END OF EXECUTION-STAR I have checked other's post,there should be a file of abort in my directory. But acturally, there is no the file of abort in my directory.When I run star out of the module of prostar,the calculation will not terminated. Can anyone tell me why it happens and how can I solve this problem. Thanks a lot!! |
|
|
||
|
December 2, 2004, 06:39
|
Re: JOB STOPPED BY USER INTERVENTION
|
#2 |
|
Guest
Posts: n/a
|
What is mentioned before this message?
|
|
|
|
||
|
December 3, 2004, 01:17
|
Re: JOB STOPPED BY USER INTERVENTION
|
#3 |
|
Guest
Posts: n/a
|
Thanks you your reply!
I have deleted all the files but the .mdl file,and run star again,and it do well! |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stopped in routine ENFORCE_BOUNDS | Ram | CFX | 3 | November 13, 2019 22:00 |
| OpenFOAM Message Board Email notification stopped working | mbeaudoin | OpenFOAM Bugs | 3 | January 8, 2009 22:08 |
| CFD of Subsea Well Intervention Device | Dash Swift | Main CFD Forum | 1 | April 17, 2006 14:09 |
| new user | michael | FLUENT | 1 | April 22, 2005 18:12 |
| User viscosity routine and user scalars? | Jeff | Siemens | 3 | January 6, 2003 05:26 |
Linear Mode
