thp question of moving grid

April 19, 2005, 05:48

hi ,dear all:

I run a model of moving grid.But when it begins to run the program,always disply the error message.The message is "Error#240 96 master faces and 96 slave face remain unmatched; check moving grid command or change area tolerance factor". Can any one give some advice about the problem?

May 29, 2005, 05:01

hello!When you run the model using ASI as tut11-1,you will get the result.I have the same problem like you,but when i have modified the cgrid.cgrd,i got the correct result.Please refer to tut13-1,understand the content of it and you will solve your problem.you can contact me by QQ:359489266.

April 19, 2005, 05:48	thp question of moving grid	#1
ricklee Guest Posts: n/a	hi ,dear all: I run a model of moving grid.But when it begins to run the program,always disply the error message.The message is "Error#240 96 master faces and 96 slave face remain unmatched; check moving grid command or change area tolerance factor". Can any one give some advice about the problem?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
moving grid	mazaheri	FLUENT	1	July 19, 2006 12:07
moving grid	Dr C.Bhasker	Siemens	4	August 31, 2005 02:29
some question about moving grid and fortran	shure	Siemens	4	April 18, 2005 22:12
Moving Body Grid Question	Matt	Main CFD Forum	5	September 13, 2004 00:45
Moving grid(BC)	faithkim	Main CFD Forum	11	September 11, 1999 14:07

May 29, 2005, 05:01	Re: thp question of moving grid	#2
roger Guest Posts: n/a	hello!When you run the model using ASI as tut11-1,you will get the result.I have the same problem like you,but when i have modified the cgrid.cgrd,i got the correct result.Please refer to tut13-1,understand the content of it and you will solve your problem.you can contact me by QQ:359489266.