 |
 |
 |
|
|
|
[Sponsors] | ||||
Scalar problem with refined mesh- HELP PLEASE |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 11, 2005, 20:35
|
Scalar problem with refined mesh- HELP PLEASE
|
#1 |
|
Guest
Posts: n/a
|
I am modeling a scalar which is a function of velocity. It works fine with a relatively coarse mesh (47 by 400), but when I have refined mesh (125 by 1800) the results become wierd near the wall. I am using low Reynolds number model, and the wall boundary conditin for the scalar is ADIABATIC (as I require it to be zero gradient at the wall). Does anyone have any idea why? The source terms are,
S1P = DEN * SQRT(U**2 + V**2) S2P = 0.0 The diffusivity term is, DIF = 10.*(VISM+VIST) I am modelling a flat plate (0.3m by 2m) with inlet, outlet and symmetry boundary conditions. Thanks |
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: Convergence problem for refined grid | CFD_Novice | Main CFD Forum | 13 | February 17, 2008 22:56 |
| [Technical] How to generate refined 3D tetrahedra etc mesh for free | kar | OpenFOAM Meshing & Mesh Conversion | 8 | January 29, 2008 04:21 |
| Two problems about interface and refined grid | peter.zhao | FLUENT | 0 | August 21, 2006 10:59 |
| Refined mesh for flat plate | StarCD | Siemens | 0 | May 31, 2004 10:52 |
| visual3 can't work with refined mesh | dell | Siemens | 0 | December 15, 2002 05:00 |
Linear Mode
