Meshing Units

July 20, 2005, 05:22

Hi

I transfered a .igs file to Pro-am to mesh, the units where mm and when tranfered it changed them to {m), how can a change the units of the whole mesh without redoing the whole mesh again?

And to avoid this happening again how can i tell when a transfer a file to pro-am that it respects the units of the geometry?

July 20, 2005, 05:24

the units in pro-STAR (and pro-AMM) are all the same 1 to 1 so you mesh is in pro-STAR units, if you want to run it in mm you just need to set the scale factor on the geom write.

July 20, 2005, 05:22	Meshing Units	#1
Nalleli Guest Posts: n/a	Hi I transfered a .igs file to Pro-am to mesh, the units where mm and when tranfered it changed them to {m), how can a change the units of the whole mesh without redoing the whole mesh again? And to avoid this happening again how can i tell when a transfer a file to pro-am that it respects the units of the geometry?

July 20, 2005, 05:24	Re: Meshing Units	#2
Ben Guest Posts: n/a	the units in pro-STAR (and pro-AMM) are all the same 1 to 1 so you mesh is in pro-STAR units, if you want to run it in mm you just need to set the scale factor on the geom write.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Units?	Skander	FLUENT	1	February 5, 2007 09:10
Units GAMBIT	VIRGINIE	FLUENT	2	November 10, 2005 17:37
What's the units in UDF?	Erica	FLUENT	3	March 3, 2005 18:40
What's the units?	ocy	FLUENT	3	February 23, 2005 21:40
Units of P	CFD guy	Phoenics	1	December 29, 2004 05:35