 |
 |
 |
|
|
|
[Sponsors] | ||||
July 27, 2005, 06:58
|
Negative Volume Problem
|
#1 |
|
Guest
Posts: n/a
|
Hi,
Bear with me Im very new at Star CD. I have been using pro am to creat a mesh of trimmed cells around a wing shape. The trim cell function in pro am however is giving me some trouble in the form of two negative volume cells at the trailing edge of my wing. What are ways I can go about fixing those cells. Thank you. |
|
|
||
|
July 27, 2005, 07:05
|
Re: Negative Volume Problem
|
#2 |
|
Guest
Posts: n/a
|
Im apologize. Please ignore my message as I realize this has already been talked about in the discussion board.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| negative volume | Rishikesh | FLUENT | 2 | February 17, 2009 04:34 |
| Negative Volume | Armin | FLUENT | 5 | April 27, 2008 16:19 |
| Negative volume problem in Two-way FSI coupling | fred | CFX | 3 | August 16, 2006 10:03 |
| negative volume 2d | AJG | FLUENT | 4 | April 21, 2006 06:52 |
| Help: Negative Volume | MANOJKUMAR | FLUENT | 8 | December 24, 2005 04:59 |
Linear Mode
