Non Manifold Error

October 15, 2005, 19:08

I have created a exhaust duct model in ProE and imported it into prosurf in CGNS format. It shows a lot of errors in terms of incomplete/short curves and when I run the automatic correction it gives the non-manifold error. Can anyone tell me how to tackle these errors.

October 19, 2005, 02:13

try to get it in iges or stl format. That gives better accuracy.

October 20, 2005, 15:35

Thanx for the reply. I tried with iges format but it still gives the same number of errors(non manifold)

dhruv

October 15, 2005, 19:08	Non Manifold Error	#1
Dhruv Guest Posts: n/a	I have created a exhaust duct model in ProE and imported it into prosurf in CGNS format. It shows a lot of errors in terms of incomplete/short curves and when I run the automatic correction it gives the non-manifold error. Can anyone tell me how to tackle these errors.

October 19, 2005, 02:13	Re: Non Manifold Error	#2
Mahesh Guest Posts: n/a	try to get it in iges or stl format. That gives better accuracy.

October 20, 2005, 15:35	Re: Non Manifold Error	#3
Dhruv Guest Posts: n/a	Thanx for the reply. I tried with iges format but it still gives the same number of errors(non manifold) dhruv

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Intake Manifold	David Baker	FLUENT	1	December 31, 2013 08:26
manifold	alireza	CFX	3	February 17, 2008 05:17
Non-manifold Curves Error, pls help	Shariff	Siemens	7	July 11, 2006 01:13
non manifold curve error	nirmal	Siemens	0	February 10, 2006 03:06
non manifold error for bullet shape object	Richard	CFX	0	January 26, 2006 23:41