Residual is sky high in Starccm+

jsb12136 · October 28, 2014, 10:58

I am using Starccm+ 9 to simulate the rotation of a vertical axis water turbine (only one blade). It runs well in the first half cycle but it crushes in the other half. The residual runs sky high. What is the problem of this?

lcarasik · October 28, 2014, 11:08

You're asking an incredibly generic question without provide any details.

Pauli · October 29, 2014, 08:46

What is it crushing?

Quote:

Originally Posted by jsb12136

I am using Starccm+ 9 to simulate the rotation of a vertical axis water turbine (only one blade). It runs well in the first half cycle but it crushes in the other half. The residual runs sky high. What is the problem of this?

October 28, 2014, 10:58	Residual is sky high in Starccm+	#1
jsb12136 New Member Xiaosong Zhang Join Date: Oct 2014 Posts: 14 Rep Power: 11	I am using Starccm+ 9 to simulate the rotation of a vertical axis water turbine (only one blade). It runs well in the first half cycle but it crushes in the other half. The residual runs sky high. What is the problem of this?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
simpleFoam error - "Floating point exception"	mbcx4jc2	OpenFOAM Running, Solving & CFD	12	August 4, 2015 02:20
Unstabil Simulation with chtMultiRegionFoam	mbay101	OpenFOAM Running, Solving & CFD	13	December 28, 2013 13:12
pimpleFoam: turbulence->correct(); is not executed when using residualControl	hfs	OpenFOAM Running, Solving & CFD	3	October 29, 2013 08:35
calculation stops after few time steps	sivakumar	OpenFOAM Running, Solving & CFD	7	March 17, 2013 06:37
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 05:24

October 28, 2014, 11:08		#2
lcarasik Senior Member Lane Carasik Join Date: Aug 2014 Posts: 692 Rep Power: 14	You're asking an incredibly generic question without provide any details.