|
[Sponsors] |
March 20, 2006, 21:02 |
Moving Bed
|
#1 |
Guest
Posts: n/a
|
Hi all,
I want to simulate a moving bed in a cylindrical tube. Hot air inlets from the tube side near the bottom and leaves near the top. Cold spheres enters from the top and leave the bottom of the tube. The Spheres flow rate at inlet equals that at the outlet and the tube is always full. The speed of the spheres is slow in comparison to the air. I want to determine the temperature distribution at steady state. Thanks a lot in advance. Ahmad |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving Reference frame - UDF - Moving mesh | modisa | FLUENT | 0 | April 18, 2008 14:31 |
moving car | Frank | FLUENT | 1 | June 30, 2006 17:45 |
Moving interface | Unal | FLUENT | 4 | April 16, 2004 11:02 |
moving bed. | MP | CFX | 0 | February 9, 2003 19:51 |
Moving Bed | MP | FLUENT | 1 | January 13, 2003 00:27 |