V4 very slow!
I have recently switched to V4 and found that is incredibly slow. I have a model that is ~1.8 million cells and it takes over a half an hour to decompose the mesh and do the geometry calcs. It does not take nearly this long with earlier versions. Has anyone else experienced this problem? Thanks.
Steve |
Re: V4 very slow!
I've run a model with more than 3 million cells (tet+prism) and v4 was more than 2 times faster than v326.
Prostar_v4 is a bit slower and "getc flux" takes ages. |
Re: V4 very slow!
We had faced the same problem with Ver 3.26. fOR GEOMETRY CALCULATIONS OF 2.4 million cells it was taking around 1/2 hour IN 4.0 gb RAM iTANIUM 2 m/c.
|
Re: V4 very slow!
Did you ever figure out why? I believe the problem has to due with my model. I have ~800-900 inlet boundary regions (individual cooling holes) and the .mdl file is only ~130 Mb but the .ccm file is over 800 Mb.
|
All times are GMT -4. The time now is 07:32. |