found crack in prostar but no crack in CCM+ ??
I generated polyhedral mesh in StarDesign. Then imported the .CCM to starcd v4 and CCM+ 2.0. In v4, I found cracks in the model. In CCM+ 2.0, the mesh was good. Did anyone encounter this problem ? This is weird. Did I make any mistakes ?
-E.Ingear |
Re: found crack in prostar but no crack in CCM+ ??
I think because there is no couple match in ccm+ so that there is no crack.
|
Re: found crack in prostar but no crack in CCM+ ??
Just ignore it. I observed the same with some meshes generated with ccm+ , but there was no problem running the calculation.
|
Re: found crack in prostar but no crack in CCM+ ??
Thank You.
|
Re: found crack in prostar but no crack in CCM+ ??
hi i need to crack for:
1- mycafecup 2- softperfect bandwidth manager thank,s |
All times are GMT -4. The time now is 19:08. |