|
[Sponsors] |
found crack in prostar but no crack in CCM+ ?? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 2, 2006, 16:18 |
found crack in prostar but no crack in CCM+ ??
|
#1 |
Guest
Posts: n/a
|
I generated polyhedral mesh in StarDesign. Then imported the .CCM to starcd v4 and CCM+ 2.0. In v4, I found cracks in the model. In CCM+ 2.0, the mesh was good. Did anyone encounter this problem ? This is weird. Did I make any mistakes ?
-E.Ingear |
|
August 2, 2006, 22:44 |
Re: found crack in prostar but no crack in CCM+ ??
|
#2 |
Guest
Posts: n/a
|
I think because there is no couple match in ccm+ so that there is no crack.
|
|
August 3, 2006, 00:45 |
Re: found crack in prostar but no crack in CCM+ ??
|
#3 |
Guest
Posts: n/a
|
Just ignore it. I observed the same with some meshes generated with ccm+ , but there was no problem running the calculation.
|
|
August 3, 2006, 14:12 |
Re: found crack in prostar but no crack in CCM+ ??
|
#4 |
Guest
Posts: n/a
|
Thank You.
|
|
October 23, 2006, 10:37 |
Re: found crack in prostar but no crack in CCM+ ??
|
#5 |
Guest
Posts: n/a
|
hi i need to crack for:
1- mycafecup 2- softperfect bandwidth manager thank,s |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crack problems | Sara | Siemens | 3 | August 6, 2008 13:18 |
Crack error in STAR-CD | Sachin | Siemens | 3 | April 17, 2008 02:13 |
crack in sector mesh | escapist | Siemens | 2 | May 19, 2005 08:25 |
How to crack this problem | Lee | Siemens | 2 | September 12, 2003 11:40 |
Crack problems again | Carlos Saraiva | Siemens | 2 | January 31, 2003 05:12 |