Boundary baffle error 258
Hi there,
I'm using a baffle boundary as a wall in a small region of my simulation. The flow is inviscid, therefore I have applied slip condition on both sides of the baffle. But when i run my simulation, I can see near the wall effects of viscousity, which were not present when I was using a normal wall boundary, can anyone tell me what is happening. The second problem I have is, I performed an adaptive grid refinement to capture my regions of interest. When I try to create the geometry file the following message appears: *ERROR - FACE DEFINED BY VERTICES [1029,1030,2141,2140] IS ONLY DEFINED BY BOUNDARIES OR BAFFLES BOUNDARY 355, BAFFLE 3782 *ERROR - THE BAFFLE BETWEEN CELLS -1 AND -1 hAS A BAFFLE BOUNDARY DEFAULTED TO REGION 0. THIS IS NOT ALLOWED WHEN RADIATION IS TURNED ON IN EITHER CELL. I've already merged cells and vertices, tried coupling, also, I've checked if the radiation was turned on the baffle boundary conditions and on my general model. I do not know what else to do. Could someone help me? Thank you before hand. Nalleli |
Re: Boundary baffle error 258
do you have baffle shells in there?
|
Re: Boundary baffle error 258
Yes, I have baffles shells in that region. And have specified them as baffle boundaries.
|
All times are GMT -4. The time now is 21:02. |