keyboard problem,OS is windows XP ..

January 19, 2007, 05:08

The keyboard is disable in prostar mode.Can anybody give me some suggestions? I have installed starcd3.26 on my computer before,and it can be properly run.But this time I reinstalled starcd3.26 I found that I was getting warning messages of the type "Warning: translation table syntax error: Unknown keysym name: osfActivate". Note, the warning message may also specify the following as unknown keysyms: osfCancel, osfSelect, osfHelp, osfBeginLine, osfUp, and osfDown,then the keyboard can't be used in prostar. Whole installation process is the same as before,i used sco xvison for x-display.And,i tried hummingbird exceed but can't solve that problem. One important thing is that everything is ok when i installed starcd in another computer which have not installed any starcd on before. What can i do now? any suggestion for me?It make me ill.

January 22, 2007, 13:32

I have seen this problem before. You need to pick up your keyboard and move and shake it left/right and up/down. It should reactivate the keysym device. It is because of static electricity.

Otherwise you will have to call an IT repair guy to open it.

IT administrator

February 9, 2007, 10:46

Hmm... Are you kidding me? After i posted my previous words i reinstalled my operation system.Then STAR-CD work normally. anyway,you are a funny boy.

scott

January 19, 2007, 05:08	keyboard problem,OS is windows XP ..	#1
Scott Guest Posts: n/a	The keyboard is disable in prostar mode.Can anybody give me some suggestions? I have installed starcd3.26 on my computer before,and it can be properly run.But this time I reinstalled starcd3.26 I found that I was getting warning messages of the type "Warning: translation table syntax error: Unknown keysym name: osfActivate". Note, the warning message may also specify the following as unknown keysyms: osfCancel, osfSelect, osfHelp, osfBeginLine, osfUp, and osfDown,then the keyboard can't be used in prostar. Whole installation process is the same as before,i used sco xvison for x-display.And,i tried hummingbird exceed but can't solve that problem. One important thing is that everything is ok when i installed starcd in another computer which have not installed any starcd on before. What can i do now? any suggestion for me?It make me ill.

January 22, 2007, 13:32	Re: keyboard problem,OS is windows XP ..	#2
IT administrator Guest Posts: n/a	I have seen this problem before. You need to pick up your keyboard and move and shake it left/right and up/down. It should reactivate the keysym device. It is because of static electricity. Otherwise you will have to call an IT repair guy to open it. IT administrator

February 9, 2007, 10:46	Re: keyboard problem,OS is windows XP ..	#3
scott Guest Posts: n/a	Hmm... Are you kidding me? After i posted my previous words i reinstalled my operation system.Then STAR-CD work normally. anyway,you are a funny boy. scott

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Dead Keyboard in paraFoam	pavodive	ParaView	10	March 30, 2020 18:42
GUI Setting & Keyboard shortcut in ICEM CFD10	Amod Kumar	CFX	1	July 7, 2014 05:11
help: udf compiling problem on 64 bit windows XP	Hsieh	FLUENT	2	September 10, 2009 04:51
FLUENT AIX export to LINUX keyboard not working	ZaPiTo	FLUENT	0	December 7, 2006 18:43
UDF compiling problem in Windows	Mazyar	FLUENT	1	April 26, 2006 01:48