 |
 |
 |
|
|
|
[Sponsors] | ||||
November 5, 2007, 17:32
|
Segmentation fault.
|
#1 |
|
Guest
Posts: n/a
|
Hi everybody..
I have installed STAR-CD and STAR-CCM+ in Linux (all are 32 bit versions). But after writing "prostar" or "proam" or "starccm+" in konsole or terminal i got segmentation fault error. And nothing is running.. I know this is may be frequently asked question.. and all are may be because of my hardware configuration.. but i must fix it immidiately.. Have anyone any suggestion for fixing it? Thanks already.. |
|
|
||
|
November 8, 2007, 04:41
|
Re: Segmentation fault.
|
#2 |
|
Guest
Posts: n/a
|
What is the exact error message? Did you set environment properly?
|
|
|
|
||
|
November 8, 2007, 04:47
|
Re: Segmentation fault.
|
#3 |
|
Guest
Posts: n/a
|
only there is written "segmentation fault"..
i did all sayed in installation guide.. what else can i do? if you have any suggestion please write.. |
|
|
|
||
|
November 8, 2007, 05:04
|
Re: Segmentation fault.
|
#4 |
|
Guest
Posts: n/a
|
Search this site. You will find much information about it. This error depends on the case. There isn't the only answer to fix it. It can be many things. Just search this forum, hope you will find something.
Regards |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Technical] Segmentation fault in map | msg30 | OpenFOAM Meshing & Mesh Conversion | 6 | March 27, 2008 10:49 |
| Segmentation fault | billy | OpenFOAM Installation | 20 | April 23, 2007 22:57 |
| segmentation fault | natesan | Siemens | 4 | January 12, 2004 08:51 |
| Segmentation fault | Veebs | Siemens | 3 | June 4, 2002 22:17 |
| Segmentation fault | Jose Sanchez | Siemens | 1 | December 16, 2001 08:13 |
Linear Mode
