Using v3.26 in v4.02
 

I am trying to run a moving mesh problem that was set up in version 3.26 in version 4.02 but I get an error that says "can't find .ccm file" does anyone know how I can convert the .geom and .pst files into a .ccm file? Thanks

Re: Using v3.26 in v4.02
 

I think you can not. You have to run calculation once again in 4.02 for getting *.ccm file.

Regards

Re: Using v3.26 in v4.02
 

You can't convert a .geom or .pst file to .ccm. You need to start with the prostar .mdl file and write a new .ccm geometry file. You may be able to do a restart from an old .pst file (not sure).

Re: Using v3.26 in v4.02
 

It is also worth remembering that if you have sliding interfaces your model won't work unless you use the latest version 4.06

Re: Using v3.26 in v4.02
 

Why on earth would you want to work in Star 4.X??

Star 4.x is a CD-adapco ploy to get you to switch to ccm+.

Re: Using v3.26 in v4.02
 

Why wouldn't you want to switch to ccm+ once it is fully developed? It is much easier to use. I would be using it if it could to moving mesh stuff. I'm using 4.02 because that's what i have access to at the moment.