|March 5, 2009, 14:27||
setting NCTMXD=NCMAX in parm.inc
I am running a steady state, low Reynolds number, to examine droplet with a water spray, the following error message stops the run:
"STOP-FOR THERMAL DIFFUSION, PLEASE RESET NCTMXD=NCMAX IN parm.inc AND GENERATE NEW EXECUTABLE"
I do as the message wants; but with next run, parm.inc is changed back to former values and the same error message stops the run.
Then I generated new executable, leads to new error that it needs "tran.dat".
Thanks a lot in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|B.C. setting||PK||FLUENT||0||September 28, 2007 03:46|
|Setting up a FAN||BEN||FLUENT||0||March 25, 2006 23:36|
|BC setting||Richard||CFX||1||March 20, 2006 11:49|
|setting NCTMXD=NCMAX in parm.inc||ROr||CD-adapco||2||November 4, 2005 10:40|
|Parm.inc error when running analysis||Chris Wood||CD-adapco||3||November 1, 2004 13:28|