CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   CD-adapco (https://www.cfd-online.com/Forums/cd-adapco/)
-   -   Plotting Parameter vs Angular Position in STAR-CCM+ (https://www.cfd-online.com/Forums/cd-adapco/86054-plotting-parameter-vs-angular-position-star-ccm.html)

Reynolds March 13, 2011 15:46

Plotting Parameter vs Angular Position in STAR-CCM+
 
Hello,

This is a fairly trivial question. I am modelling flow around tyres and want to plot the Cp (on y axis) vs angular position (in degrees) on the x axis. I can only seem to be able to plot axial position however.

Does anyone know a way to do this, or even if this feature exists in STAR?

Best Regards,
Matt

---------------------------------------------------------------------------
I should add that the data in question is read from a plane section that cuts through the mid point of the tyre

Pauli March 14, 2011 18:47

Yes it can be done. Query the "y" position in a cylindrical coordinate system.

Reynolds March 22, 2011 10:42

Thanks Pauli.

For those with similar problem, set up a cylindrical co-ord, then go to the plot in question. Under 'X TYPE' select scalar, then under scalar select position/position in cylindrical 1/theta.

I am using star-ccm+ 5.06.010

Matt


All times are GMT -4. The time now is 00:15.