OpenFOAM-advice needed
 

Hi,

I am absolute beginner in OpenFOAM and I need somebody who can help me to run a case because I stuck with it. I live in Munich Germany.

I have already created a Mesh with blockMesh with several Patches and I want to rotate those patches with solidBodyMotion multiMotion.

All I know is, it could work with AMI/MRF. I want to modify the mixerVesselAMI2D tutorial in pimpleDyMFoam to do this.

Could anybody help me to make my case run?

Best regards,
Alex

Are you willing to pay for this help?

Hi Pete,

yes of course, well I have to say I am only student at the moment so the price must be reasonable.

Make me an offer.

Regards,
Alex

Great, I just wanted to confirm that since this forum is for paid services and your message was not very clear on that. I hope that you find some good help.

Helo Alex,

I'm an aeronautical engineer holding two degrees(mechanical engineering and Research Master obtained at the von Karman Institute for Fluid Dynamics). My diploma thesis was an incompressible fan flow simulation with MRFsimpleFoam in steady, and pimpleDyMFoam in unsteady using AMI surfaces. I have experience in building up, meshing and setup rotating machinery cases in OpenFOAM and ANSYS (I worked in compressors in CFX before).

I've sent you the details in a separate private message.
Attesz