 |
 |
 |
|
|
|
[Sponsors] | ||||
October 13, 2014, 09:57
|
[CFD] air-water cyclone separator
|
#1 |
|
New Member
Tom
Join Date: Mar 2014
Posts: 19
Rep Power: 12  |
Hello,
I have a question concerning diffusion inertia model. According to some readings this model is adequate for low inertia particles (dimensional relaxation time has to be lower than 100). My question is, would it be a "good" approach to use such a model for CFD simulation of air-water cyclone separator (dispersed media are droplets of water of course)? Thanks you in advance. Regards, Luke |
|
|
|
|
|
November 29, 2014, 01:04
|
|
#2 | |
|
Member
Mehul Patel - CFD Expert
Join Date: Jul 2013
Location: Ahmedabad
Posts: 41
Rep Power: 12 |
Quote:
Is the problem still open for correction? |
||
|
|
|
||
|
December 1, 2014, 17:16
|
|
#3 |
|
New Member
Tom
Join Date: Mar 2014
Posts: 19
Rep Power: 12 |
Yes, I'd be glad to you if you could answer my question
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water diffusion into air | MGabr | CFX | 19 | September 3, 2023 19:06 |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Mass Transfer Between AIR and WATER | Math13570 | CFX | 12 | June 29, 2016 08:14 |
| Is it possible to integrate air through a system with mixture of air and water? | Hale | OpenFOAM Post-Processing | 1 | September 30, 2013 08:57 |
| I am NOT getting right pressure at the air inlet in water column | kcfd | FLUENT | 0 | November 24, 2012 23:14 |
Linear Mode
