|
[Sponsors] |
how do i draw the nozzle part?refer attached image.really need help. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 10, 2016, 12:03 |
how do i draw the nozzle part?refer attached image.really need help.
|
#1 |
New Member
ashraf
Join Date: Aug 2016
Posts: 3
Rep Power: 9 |
I'm doing ansys simulation on a spray system.Right know i had try to draw my own version of geometry by referring to the journal but it does not seem to work as i cant get the same result as the one in the journal.i had been advised to develop new geometry.From the journal it said that "In the model, the spray is injected into three concentric circles with different radii: 20, 30, 40 mm, based on the average spray plume sizes at the breakup length of different hollow-cone nozzles tested in spray characterisation experiments"
|
|
August 11, 2016, 10:47 |
|
#2 |
New Member
Matt Levins
Join Date: Nov 2014
Posts: 17
Rep Power: 11 |
There is options in Fluent to what type of injection (Cone, single droplet, etc.)
|
|
August 11, 2016, 14:52 |
|
#3 |
New Member
ashraf
Join Date: Aug 2016
Posts: 3
Rep Power: 9 |
||
August 11, 2016, 15:49 |
|
#4 |
New Member
Matt Levins
Join Date: Nov 2014
Posts: 17
Rep Power: 11 |
you dont draw the actual nozzle. Just specify the location and orientation..........
|
|
August 11, 2016, 16:01 |
|
#5 |
New Member
Matt Levins
Join Date: Nov 2014
Posts: 17
Rep Power: 11 |
you can also specify an injection type as surface
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 15:18 |
Convergent-Divergent Nozzle with MATLAB | Obad | Main CFD Forum | 8 | June 2, 2020 15:10 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 09:44 |
calculation of thrust thrugh a pipe with CD nozzle | izhar | Main CFD Forum | 0 | February 28, 2009 10:22 |
compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 02:45 |