error in CFX remesh
Hi.
I made geometry and mesh of a cylinder in 3D domain, and then exported to the CFX. All configurations were set same as ANSYS Tutorial:CFX Re-Meshing. But, an error was raised at the beginning of solving about high skewed of elements. I cannot understand, if CFX wants to create a new mesh, why should make an error about skewed one? :confused: |
It is not an error, it is a warning. The simulation can still proceed. But bad quality meshes are best avoided and time spent improving mesh quality is worth it.
|
All times are GMT -4. The time now is 12:43. |