|May 8, 2012, 03:53||
pipe problem boundary conditions(please help me to solve this)
Join Date: Mar 2012
Posts: 7Rep Power: 5
i have to apply boundary conditions for a straight pipe with same diameter through out with 1 inch length and .35 inches dia.
flow rate =.00026
inlet pressure 5000psi
i want to get the outlet pressure
when i am giving static pressure the solver is considering the total pressure also the same.this flow is through hydraulic system and it s outlet is not in contact with atmosphere.
while defining fluid domain what should be the relative pressure for this particular case.????
|May 8, 2012, 04:18||
Join Date: Feb 2012
Posts: 40Rep Power: 6
I presume the flow rate is in [kg/s] and velocity is in [m/s].
Because this is very short length of pipe, you would have to define your boundary conditions away from the actual ones i.e increase the length of the pipe. You can define inlet as mass flow while the outlet as an opening.
|May 8, 2012, 06:59||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 12,834Rep Power: 100
Mahe - firstly, please do not PM me duplicate of your posts. Do not turn your posts into spam.
Following on from Raja's comment - your pipe is so small that the flow will be dominated by upstream and down stream effects. You cannot model a 1 inch by 0.35 inch diamater pipe in isolation and hope to get meaningful answers.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with assigned inlet velocity profile as a boundary condition||Ozgur_||FLUENT||5||August 25, 2015 04:58|
|Problem with a periodic boundary condition||chuck209||CFX||10||May 9, 2012 16:15|
|Problem with "symmetryPlanne" boundary condition||fcuevas||OpenFOAM Running, Solving & CFD||1||March 14, 2012 06:07|
|CFX13 Post Periodic interface||EtaEta||CFX||7||December 8, 2011 18:15|
|a problem with Boundary condition||M Rad||Main CFD Forum||12||November 27, 1998 13:49|