Hello,

I have made a mesh in Gambit and I would like to import it in cfx-pre. I tried exporting from Gambit both with the Ansys and the CGNS format, as is suggested on some messages in this forum. The problem is that when I import the mesh in CFX-PRE 10.0 all the information about the geometry is lost (I am not able to select the faces for example). Is there a way to import the geometry information in CFX-PRE?

Thanks Francesco

I am also doing similar kind of thing so what I do in my case is to make a mesh in gambit it is a 2D mesh and then converting that mesh from infot foam format and then converting the foam mesh to 3D mesh now 2D mesh is converted into 3D mesh. Now I am improting that mesh in tgrid and exporting it in the format of ptran and then I am able to see all the boundary cndition and mesh proerly in CFX-PRE.

I hop it helps you Q

[yahya_a]

hi
i have a mesh from gambit
when i import it in cfx-pre, other mesh that i have created lost!

[ghorrocks]

I cannot test this as I am at home at the moment, but I thought CFX-Pre could import gambit msh files.

[yahya_a]

Originally Posted by ghorrocks

I cannot test this as I am at home at the moment, but I thought CFX-Pre could import gambit msh files.

yes, you are right
but as i said, when i import mesh, other meshes that i create in turbo grid removed!
i record a movie from my problem:
http://www.mediafire.com/?6o6o667se6zdbmm

[Far]

use turbomode and import mesh for as many components as you want.

[yahya_a]

Originally Posted by Far

use turbomode and import mesh for as many components as you want.

i did it before, same problem exist

[Far]

it seems that you have scaling problem. Check the units. All meshes are there but you can not see them due to scaling problem.