|
[Sponsors] |
Flow through pipe bend tutorial - Solver Error |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Andrew Smith
Join Date: May 2012
Posts: 3
Rep Power: 14 ![]() |
Anyone have any ideas of what the issue could be?
![]() |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,934
Rep Power: 145 ![]() ![]() ![]() ![]() |
Sounds pretty obvious. You do not have a valid definition file. This is probably because of a problem in CFX-Pre so it did not generate a def file and the rest of the workbench system failed to execute because of it.
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Andrew Smith
Join Date: May 2012
Posts: 3
Rep Power: 14 ![]() |
Thanks,
To be more specific, this is the problem in CFX-pre: ![]() |
|
![]() |
![]() |
![]() |
![]() |
#4 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 23 ![]() |
The error says that you have specified two boundary conditions at the same location (inlet). Why not change it?
|
|
![]() |
![]() |
![]() |
![]() |
#5 |
New Member
Andrew Smith
Join Date: May 2012
Posts: 3
Rep Power: 14 ![]() |
The intention was obviously not to specify two boundary conditions at the inlet,
there is no-slip at the walls, symmetry of the side faces and inflow and outflow boundary conditions specified. |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 07:11 |
[Netgen] Installation of Netgen in SuSE Linux 92 | edvardsenpriv | OpenFOAM Meshing & Mesh Conversion | 23 | January 16, 2009 06:12 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |