Reynolds number error - CFX
 

I stopped a CFX run after 2262 iterations but I noticed the error " Reynolds number is out of range " when the run is stopped.

The reynolds number was reported to be low when the run started and I didn't see such error then but I found it to be higher after stopping the run.

I didn't even notice any intermittent errors (or) warnings when the run was going on.

Please find attached a pdf that shows the excerpts from the .out file.

Could some one please comment on this

This question has been asked thousands of times. DO a search on the forum for mre details.

In short, it is just a warning, not an error. If it is not applicable to you then ignore it.