CFX-Solver

sainath.s@tdps.co.in · July 4, 2012, 06:27

There is no issue with the solver just that it is diverging. Just set you reference pressure on the higher side to your reality conditions(>20 MPa) and set opening relative pressures to zero.

Also have you checked the direction of rotation of your gears????? Why dont you try starting your problem under steady state conditions and then move on to your transient conditions.

shanxuewenjdx · July 15, 2012, 21:05

It‘s the issue of mesh,for mesh quality of the domain is below 0.3.

Thanks all !

shanxuewenjdx · July 15, 2012, 21:08

But this simulation is not basically consistant with the experiment.
In the first picture,this groove doman is connected with fluid domain with the method of "Domain Interface".

shanxuewenjdx · August 12, 2012, 21:26

Hello，Still a question about my simulation? I suppose the unreal pressure picture above is due to leakage. So is there anyone who has familiar experience with gear pump? Since the massFlow at outlet is not consistant with the actual situation, what's the reason ?And what can be done?
Many thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error message CFX Solver	Fatnes	CFX	25	July 3, 2015 10:32
CFX SOLVER error !!!	mehrdadeng	CFX	3	November 23, 2009 16:42
mach number and CFX 11.0 solver	turbinesv	CFX	5	January 5, 2009 05:43
CFX Solver to run 10 files sequentially	Raj	CFX	8	October 29, 2008 22:20
problem in CFX solver about isolated volumes	Yuan	CFX	2	August 16, 2004 22:54

July 4, 2012, 06:27		#41
sainath.s@tdps.co.in New Member Sainath Join Date: Mar 2012 Posts: 27 Rep Power: 14	There is no issue with the solver just that it is diverging. Just set you reference pressure on the higher side to your reality conditions(>20 MPa) and set opening relative pressures to zero. Also have you checked the direction of rotation of your gears????? Why dont you try starting your problem under steady state conditions and then move on to your transient conditions.

July 15, 2012, 21:08		#43
shanxuewenjdx Member Stefan Join Date: May 2012 Posts: 49 Rep Power: 13	But this simulation is not basically consistant with the experiment. In the first picture,this groove doman is connected with fluid domain with the method of "Domain Interface".

August 12, 2012, 21:26		#44
shanxuewenjdx Member Stefan Join Date: May 2012 Posts: 49 Rep Power: 13	Hello，Still a question about my simulation? I suppose the unreal pressure picture above is due to leakage. So is there anyone who has familiar experience with gear pump? Since the massFlow at outlet is not consistant with the actual situation, what's the reason ?And what can be done? Many thanks.