How to visualize/ calculate applied heat source during post processing

lavoz · May 31, 2012, 08:55

Dear CFD Online users!

Although it appears to be a simple task I'm struggeling with the calculation of the applied heat source specified in cfx5pre during post processing. I'd go with an approach like

volumeInt(<heatSource_variable>)@subdomain

but I can't find a suitable variable for the heat source. I do not want to go with the heat flux over the connecting interfaces since I have not named them specifically and I have hundreds of subdomains resulting in even more interfaces.

Any suggestions?

ghorrocks · May 31, 2012, 18:59

I have found this also. The way I got round it was to write the heat source variable to an additional variable, then it is available in the post processor.

lavoz · June 1, 2012, 04:35

First of all thanks for your response. That's the way I got around that yesterday, but I still hoped there'd be a less tiring approach offering a plausibility check. Anyway, thank you again.

May 31, 2012, 08:55	How to visualize/ calculate applied heat source during post processing	#1
lavoz New Member Nicolas Join Date: Mar 2010 Posts: 13 Rep Power: 16	Dear CFD Online users! Although it appears to be a simple task I'm struggeling with the calculation of the applied heat source specified in cfx5pre during post processing. I'd go with an approach like volumeInt(<heatSource_variable>)@subdomain but I can't find a suitable variable for the heat source. I do not want to go with the heat flux over the connecting interfaces since I have not named them specifically and I have hundreds of subdomains resulting in even more interfaces. Any suggestions?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 10:23
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 19:08
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24
variable heat source	John	Phoenics	3	April 8, 2003 11:12

May 31, 2012, 18:59		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	I have found this also. The way I got round it was to write the heat source variable to an additional variable, then it is available in the post processor.

June 1, 2012, 04:35		#3
lavoz New Member Nicolas Join Date: Mar 2010 Posts: 13 Rep Power: 16	First of all thanks for your response. That's the way I got around that yesterday, but I still hoped there'd be a less tiring approach offering a plausibility check. Anyway, thank you again.