 |
 |
 |
|
|
|
[Sponsors] | ||||
November 5, 2013, 13:29
|
Variables
|
#1 |
|
New Member
Anon
Join Date: Nov 2013
Posts: 1
Rep Power: 0  |
Good Morning,
i am conducting runs on 2d foil simulations and am coming unstuck on other variables to change progressively. I have done the obvious mesh element and domain sizing to find independence. trying to think of other thing i could also progressively change. the runs are studying the forces of a foil. any suggestions are most welcome. regards |
|
|
|
|
|
November 5, 2013, 13:39
|
|
#2 |
|
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
|
|
|
|
|
|
|
November 5, 2013, 17:21
|
|
#3 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
This FAQ has a good list: http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Restarting a run from .trn files What variables do I need?) | Badi | CFX | 2 | December 29, 2017 22:13 |
| ADDITIONAL VARIABLES LIMITERS | N.P | CFX | 5 | December 1, 2011 07:47 |
| $FOAM_USER_APPBIN & LIBBIN variables not set | rassilon | OpenFOAM Installation | 2 | February 16, 2010 20:54 |
| PHI file structure | Eugene | Phoenics | 9 | November 2, 2001 22:00 |
| Saving variables on a user patch with physical coordinates | Zoltan Turzo | CFX | 2 | April 20, 2000 15:05 |
Linear Mode
