CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Plane in pre-cfx (

sepidecent June 12, 2012 21:14

Plane in pre-cfx
Hi All

I have a geometry of rectangular box(450mm*900mm*225mm).There is a slot at the top of the box.For defining a slot first I put a plane(from surface),then the slot was drew.The slot was exactly at the middle of the box in my pre-cfx I extract the slot with imprint method,but when I look at post-cfx the slot has been move about 2-3 mm that make the results antisymmetric.I was wondering if anybody could help.:confused:


All times are GMT -4. The time now is 11:08.