 |
 |
 |
|
|
|
[Sponsors] | ||||
June 12, 2012, 21:14
|
Plane in pre-cfx
|
#1 |
|
New Member
sepideh
Join Date: Jul 2011
Posts: 21
Rep Power: 14  |
Hi All
I have a geometry of rectangular box(450mm*900mm*225mm).There is a slot at the top of the box.For defining a slot first I put a plane(from surface),then the slot was drew.The slot was exactly at the middle of the box in my pre-cfx I extract the slot with imprint method,but when I look at post-cfx the slot has been move about 2-3 mm that make the results antisymmetric.I was wondering if anybody could help.  Regards, SEpi |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting Pressure Boundary Conditions in ANSYS CFX Pre | saisanthoshm88 | CFX | 21 | February 22, 2017 16:50 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| Under Relaxation Factors in CFX Pre | akj | Main CFD Forum | 0 | December 15, 2011 01:50 |
| Locating the Monitor Points in CFX Pre | saisanthoshm88 | CFX | 2 | November 30, 2011 09:58 |
| Setting material properties - CFX Pre | cavani | CFX | 6 | January 27, 2011 19:52 |
Linear Mode
