rotor37 mesh -- CFD Online Discussion Forums

October 12, 2012, 11:46	rotor37 mesh	#1
Ehsan01 New Member Ehsan Join Date: Oct 2012 Posts: 1 Rep Power: 0	Hello I want to use sst model in ansys cfx12 , for simulation of rotor 37 hub and shroud end wall boundary layer, I examined several different meshes and boundary conditions but I couldn’t obtain accurate answer in comparison with the AGARD experimental result and there are very error in span above 60% and near the tip (with 0.0356 cm tip clearance). It is wondering if you could guide me and send the bladeGen and mesh file to my email address. (airo_1365@yahoo.com) Thanks a lot Last edited by Ehsan01; October 29, 2012 at 06:07.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
Meshing aifoil in ICEM	student123a	ANSYS Meshing & Geometry	13	December 8, 2010 10:40
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 04:49

All times are GMT -4. The time now is 21:54.