Sail design

Umberto · October 31, 2012, 06:45

Hi everyone,
I'm am doing a project on sail flying shape prediction with ANSYS. I am using CFX in particular. As part of my project I need to carry out a flow analysis on a 2D sail profile (sail section seen from the above) and one of the requirements is that the sail should have zero thickness. I have created the geometry in GeometryModeler using the "3D curve through XYZ points" tool then extruded it by 1cm in the z direction as I know CFX doesn't deal with 2D objects. My domain is a rectangular box 1cm deep in the z direction. However, when I come to create the boolean, it would't let me and an error message comes up saying "the operation would result in non-manifold bodies".
Does anyone know how i could overcome this problem and create the boolean for the zero thickness sail?

thanks
Umberto

evcelica · October 31, 2012, 12:21

I don't know if this is the correct way to do it but you could create two bodies where the intersection between them is the 2D shape of the sail. You could put two more bodies on the side for the flow around the sail. Create a part out of it.
Then in CFX Pre, define all bodies as a single domain and model your sail shape as a wall interface. All other connections leave default (conservative interface flux)

October 31, 2012, 06:45	Sail design	#1
Umberto New Member Join Date: Oct 2012 Posts: 5 Rep Power: 13	Hi everyone, I'm am doing a project on sail flying shape prediction with ANSYS. I am using CFX in particular. As part of my project I need to carry out a flow analysis on a 2D sail profile (sail section seen from the above) and one of the requirements is that the sail should have zero thickness. I have created the geometry in GeometryModeler using the "3D curve through XYZ points" tool then extruded it by 1cm in the z direction as I know CFX doesn't deal with 2D objects. My domain is a rectangular box 1cm deep in the z direction. However, when I come to create the boolean, it would't let me and an error message comes up saying "the operation would result in non-manifold bodies". Does anyone know how i could overcome this problem and create the boolean for the zero thickness sail? thanks Umberto

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Mesh around a sail with zero thickness	ole_lindberg	OpenFOAM Meshing & Mesh Conversion	1	January 6, 2010 19:08
JOB: Sr. Thermal/Mechanical Design Engineer	Dee Dee Dial	Main CFD Forum	0	April 1, 2003 18:49
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 10:18
Any sail design /CFD conferences?	Steve Collie	Main CFD Forum	1	August 6, 1999 13:17
CFD - Trends and Perspectives	Jonas Larsson	Main CFD Forum	16	August 7, 1998 16:27

October 31, 2012, 12:21		#2
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,167 Rep Power: 23	I don't know if this is the correct way to do it but you could create two bodies where the intersection between them is the 2D shape of the sail. You could put two more bodies on the side for the flow around the sail. Create a part out of it. Then in CFX Pre, define all bodies as a single domain and model your sail shape as a wall interface. All other connections leave default (conservative interface flux)