Porosity inputs

soni7007 · February 25, 2013, 15:53

Hello,

I want to input the isotropic loss parameters (lienar and quadratic) in the form of "permeability" and the "resistance loss coefficient". I have calculated the permeability using the experimental data and the darcy's equation.
How do I calculate the "resistance loss coefficient". The units are m(-1). Is it the inverse of the filter thickness?

Thanks in advance!

cdegroot · February 25, 2013, 20:33

It is not the inverse of the filter thickness. Check the theory guide for its definition. It is a coefficient multiplying 1/2*rho*velocity^2. If the flow rate is very low (i.e. no inertial effects so Darcy's law is valid) then it can be set to zero.

February 25, 2013, 15:53	Porosity inputs	#1
soni7007 New Member CFDLife Join Date: Apr 2009 Posts: 7 Rep Power: 17	Hello, I want to input the isotropic loss parameters (lienar and quadratic) in the form of "permeability" and the "resistance loss coefficient". I have calculated the permeability using the experimental data and the darcy's equation. How do I calculate the "resistance loss coefficient". The units are m(-1). Is it the inverse of the filter thickness? Thanks in advance!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
anisotropic porosity in CFX	Chander	CFX	19	June 17, 2014 04:51
Porosity treatment in OpenFOAM	derkermit	OpenFOAM Programming & Development	0	November 20, 2012 02:57
Porosity profile, dividing a zone, or getting zone location from zone	khoopes	FLUENT	0	June 2, 2012 19:39
Problem in setting porosity region for rhoPorousSimpleFoam	run_cfd	OpenFOAM Pre-Processing	1	May 31, 2011 09:02
Porosity field in Fluent	wojciech	FLUENT	1	September 20, 2010 11:19

February 25, 2013, 20:33		#2
cdegroot Senior Member Chris DeGroot Join Date: Nov 2011 Location: Canada Posts: 414 Rep Power: 17	It is not the inverse of the filter thickness. Check the theory guide for its definition. It is a coefficient multiplying 1/2rhovelocity^2. If the flow rate is very low (i.e. no inertial effects so Darcy's law is valid) then it can be set to zero.