|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Michal
Join Date: Sep 2012
Posts: 12
Rep Power: 14 ![]() |
Hello,
i design a blade of fan in BladeGen. Then i make a mesh in TurboGrid and start with the setup in CFX. I become a solution. Then i would like to edit the geometry in BladeGen. Can I come back to the window, where i can choice betwen radial turbine, radial diffuser, simple axial, normal axial etc??It is possible? I would like to change this basic parameters and use later the same projects in TurboGrid and CFX |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
ejdaiou
Join Date: Apr 2012
Posts: 3
Rep Power: 14 ![]() |
Dear sir , would plesase send us the methode used to draw the impeller , that i want to introduce the values got in the balde designer and in eatch time a error message appear that VISTA CPD could not start , i reset the configuration of blade generator from the istall folder as recommanded , but the problem persist .
your help it's higly appreciated . thanks in advance |
|
![]() |
![]() |
![]() |
![]() |
#3 | |
New Member
Adem
Join Date: May 2014
Posts: 3
Rep Power: 12 ![]() |
Quote:
|
||
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
BladeGen problem | David Wang | CFX | 5 | April 2, 2016 06:18 |
[Other] Export Geometry in BladeGen | strobel | ANSYS Meshing & Geometry | 1 | June 13, 2012 07:50 |
Laptop for CFD - recommendation | Far | Hardware | 20 | May 31, 2012 18:01 |
BladeGen and CFX - basic question | Dip | CFX | 5 | August 5, 2010 18:21 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 12:46 |